The purpose of this project was to design a cost-effective item detector to be used as a counter in...
Embed
From Rooftop PV to 100MW Solar Resources
A few years back, I used to do rooftop PV installations with #GridAlternatives in order to learn and...
Embed
Current-Voltage Characteristics of a PN Junction
The purpose of this project was to study some basic applications of PN junction diodes in non-linear...
Embed
MOSFET and BJT Logic Inverters
In this project, the applications of MOSFET and BJT devices in digital logic circuits were studied...
Embed
Current-Voltage Characteristics of a JFET
For this project, a JFET (2N3819), an op amp, and some resistance was used to observe and measure the...
Embed
Electrical Characteristics of an Inverter
In this project, we experimented with the basic current and voltage transfer characteristics of a 7404...
Embed
Low-Power Solar Panel Controller for Mobile Device
The purpose of this project is to create a low-power solar charging station for mobile devices in remote...
Embed
Senior project involves designing an off-grid renewable power system to supply power to a farm. Senior...
Embed
ECE 309 - Control Systems Engineering Lab
This lab consisted of controlling a DC Brush-less motor with feedback using a myDAQ and a motor controller.
Embed
This project was essentially modeling a wind turbine through simulink. We were to design the aerodynamic...
Embed
This pspice project was essentially designing an error compensation amplifier in order to improve the...
Embed
Sensor system that monitors the pressure of air lines connected to each Ink container. If the pressure...
Embed